• server with installed Linux Debian 10/11 64-bit
• in case of VM it is necessary to have full virtualization (own kernel), due to use Docker containers
• subdomain blockchain.<company domain name> e.g. : blockchain.fccps.cz
• public IP address, pointing to subdomain blockchain

Send email to kozak@elachain.cz with following information:

• contact for node owner
• contact for technical person of the node (updates will be send to this contact)
• domain under which node will run in the format blockchain.YourDomain
• provider of HW/VM, where is node deployed

After receiving this information we will generate installation config .install-env which indispensable for the node installation. We will send it to you by email in encrypted archive.

minimal:

• CPU: 1 core
• RAM: 2 GB
• DISK: 30 GB

recommended:

• CPU: 2 cores
• RAM: 4 GB
• DISK: 100 GB

Next you have to setup another two subdomains:

• peer0.blockchain.<company domain name> e.g.: peer0.blockchain.fccps.cz
• peer1.blockchain.<company domain name» e.g.: peer1.blockchain.fccps.cz
• assign DNS records of these two subdomains to the same public IP address like „blockchain“ subdomain
• make sure that your provider (in case of your own HW, contact your IT department) allows access for the following ports through the firewall (all these ports are used by full installed node and its applications):
  • 7051 (TCP) - IN/OUT - used for peer0 communication
  • 8051 (TCP) - IN/OUT - used for peer1 communication
  • 3000 (TCP) - IN/OUT - gateway communication
  • 80 (TCP) - IN/OUT - http access fro applications
  • 443 (TCP) - IN/OUT - https access fro applications
  • 7050 (TCP) - OUT - communications port to orderer
• if you allow using of collectd monitoring service, you have to enable following ports to addition:
  • 25826 (UDP) - OUT
  • 8125 (UDP) for docker interface „docker_hfc_if“

Example using iptables:

iptables -A INPUT -i docker_hfc_if -p udp –dport 8125 -j ACCEPT

In case you are using nftables, add the following line to /etc/nftables.conf and reload nftables:

iifname „docker_hfc_if“ udp dport 8125 counter accept

If you want to have your own logo (see screenshot below) send us two images with a resolution of 250w X 50h px and 200w X 200h px in png format.

If you are interested in a complete list of node control commands, it is possible to create access to our wiki.